For a 5 kW / 10 kWh home battery, Ingro EMS-H is the energy management system inside the inverter. It charges the battery from rooftop solar first, holds back enough charge for the next power cut, and makes heavy loads such as air-conditioners, geysers and pumps wait when the battery or solar cannot carry them. Ingro supplies EMS-H to inverter makers and solar installers.
Ingro does not make the battery. The cabinet or container can be any maker's, with any BMS and PCS; Ingro EMS is the controller and software that decides when it charges, discharges or holds.
What a battery of this size usually looks like on an Indian site.
The sites that most often install a 5 kW / 10 kWh battery.
Use more of the day's solar in the evening instead of sending it to the grid.
Keep the lights, fans, fridge and Wi-Fi on through an outage, with a reserve the EMS protects.
The same size, where a few critical loads must not stop.
Leave your details. An Ingro engineer gets back to you within one business day, no obligation.
The battery stores energy and the PCS converts it. The EMS decides what it earns, every control cycle.
Into the house loads and the battery before the grid, so less of it is exported at a low rate.
A reserve the owner sets, held for the next power cut rather than spent on the evening peak.
AC, geyser and pump wait or run on solar, so the battery is not emptied in minutes.
EMS-H runs with the inverter and battery the maker supplies, on the same made-in-India platform that runs commercial and grid-scale storage. Systems are typically up to about 10 kW, and not limited to that.
Building batteries of this size? Ingro EMS for integrators, EPCs and pack makers · Every BMS, PCS and protocol
4 questions
An EMS that decides when the battery charges from solar or the grid, how much charge to keep for power cuts, and when heavy loads run. Ingro EMS-H does this inside the home inverter.
Yes. Home systems are typically up to about 10 kW, and EMS-H is not limited to that. Larger homes and small businesses use the same EMS.
Ingro supplies EMS-H to inverter makers and solar installers, who fit it in the systems they sell. Ask your installer, or have them contact Ingro.
It depends on the load. At 1 kW of lights, fans, fridge and Wi-Fi, a full 10 kWh battery lasts several hours; the EMS keeps the reserve you set so heavy loads do not use it up first.
Still have a question?
Share details of your site, hardware and tariff or tender, and an engineer will answer it.
One controller and one console, from a home battery to a grid-scale plant.
Send the battery and what it must do. An engineer replies within one business day.
Tell us the battery, the PCS and what it must do. An engineer replies within one business day with the EMS scope and the package that fits.